Download
Step 16: Use the cup remover tool included with the kit to remove both plastic cups on the original shifter. To do so, place the cup remover tool on top of the open jaws of a vice, the jaws should be approximately 1” apart. Hang the shifter from the tool as shown, be sure the shifter is inserted completely into the slot in the tool. Insert a punch into the center hole through the plastic cup and tap firmly with a hammer to separate the original shifter from cup. Repeat for 2nd cup.Re-Installation Install the plastic cups which you removed from the original shifter onto the TWM shifter. Grease the cups and pivot balls. Place the cup on a firm surface and push the TWM shifter into it until it pops in
Incoming search terms:
- 2000 celica gts ecu
- polini 50 motor
- polini 50
- motor schematic for 2000 harley softail heritage
- help with my 2000 hd screamin eagle wiring shortong out battery charge
- celica ecu replacing
- 2000 Softail Engine
- 2000 heritage softail wiring diagram
- 2000 fatbow starter replacement
- Wiring schematics for Harley Softail 2000